Peltonen Replacement Metsä Skins Mohair Inserts

Features:

• Easily replacable with a waxing iron:

• Carefully clean your iron with shop towel, fiberlene, or a clean rag to remove any wax on your iron`s plate.

• Set the iron to between 130C and 150C.

• Use the heat from the iron to warm the glue of your old skin inserts. Peltonen recommends using a Teflon sheet or a length of fiberlene or parchment paper between the iron and ski base to dissipate the heat more evenly reducing the risk of overheating your ski. After the glue has been warmed, it should easily peel out of the ski.

• Grab your new skin inserts and peel off the backing. Press the new skin insert into the cavity. Pay close attention to the edges of the skin to make sure good contact is made. The new inserts should lie perfectly flat.

• Once again with the iron set at 130C-150C, heat the new skin`s glue. Again, use a sheet of Teflon, fiberlene, or parchment paper between the ski and the iron to dissipate the iron`s heat. Press the iron gently and keep the iron in motion. Pass over the new skin a couple of times to make sure the glue is heated. Let cool to room temperature.